TCA6416PWG4 belongs to the category of integrated circuits (ICs).
This product is commonly used for input/output (I/O) expansion in various electronic devices.
The TCA6416PWG4 is available in a small-sized TSSOP-24 package.
The essence of TCA6416PWG4 lies in its ability to expand the number of available I/O pins in electronic devices, enabling them to connect and control more peripheral components.
This product is typically sold in reels, with each reel containing 2500 units.
The pin configuration of TCA6416PWG4 is as follows:
| Pin Number | Pin Name | Description | |------------|----------|-------------| | 1 | SDA | I2C Serial Data Input/Output | | 2 | SCL | I2C Serial Clock Input | | 3-18 | P0-P15 | Programmable I/O Pins | | 19 | VCC | Supply Voltage | | 20 | GND | Ground |
TCA6416PWG4 operates by receiving commands and data through the I2C interface. The host controller communicates with the device using the I2C serial bus protocol, enabling it to configure the individual pins as inputs or outputs. The device then responds accordingly, either reading the input state or driving the output state on the specified pins.
TCA6416PWG4 finds applications in various fields, including but not limited to:
These alternative models offer similar functionality and can be considered based on specific project requirements.
*Word count:
Sure! Here are 10 common questions and answers related to the application of TCA6416PWG4 in technical solutions:
Q: What is TCA6416PWG4? A: TCA6416PWG4 is a 16-bit I/O expander with I2C interface, which allows you to expand the number of GPIO pins in your microcontroller-based system.
Q: What is the operating voltage range of TCA6416PWG4? A: The operating voltage range of TCA6416PWG4 is from 1.65V to 5.5V.
Q: How many GPIO pins can be controlled using TCA6416PWG4? A: TCA6416PWG4 provides 16 GPIO pins that can be individually controlled.
Q: Can TCA6416PWG4 be used as both input and output pins? A: Yes, TCA6416PWG4 can be configured as either input or output pins based on your application requirements.
Q: What is the maximum current that can be sourced/sunk by each GPIO pin? A: Each GPIO pin of TCA6416PWG4 can source/sink up to 25mA of current.
Q: Can TCA6416PWG4 handle interrupts? A: Yes, TCA6416PWG4 supports interrupt functionality, allowing you to detect changes in the state of the GPIO pins.
Q: What is the I2C address of TCA6416PWG4? A: The I2C address of TCA6416PWG4 is configurable, allowing you to set it to one of eight possible addresses.
Q: Can TCA6416PWG4 be cascaded with other I2C devices? A: Yes, TCA6416PWG4 can be cascaded with other I2C devices on the same bus, as long as they have different addresses.
Q: Does TCA6416PWG4 have any built-in pull-up resistors? A: Yes, TCA6416PWG4 has configurable internal pull-up resistors that can be enabled/disabled for each GPIO pin.
Q: What are some common applications of TCA6416PWG4? A: TCA6416PWG4 is commonly used in various applications such as industrial automation, home automation, IoT devices, and embedded systems where additional GPIO pins are required.
I hope these questions and answers help you understand the application of TCA6416PWG4 better! Let me know if you have any more questions.